本文我们还是利用esp8266配合继电器制作一个简单的智能插线板。

线路图

实物

代码

#define BLINKER_PRINT Serial
#define BLINKER_WIFI
#define BLINKER_MIOT_LIGHT
#include 

char auth[] = "3aa44d779593";
char ssid[] = "PDCN";
char pswd[] = "1234567890";

// 新建组件对象
BlinkerButton Button1("btn-abc");
BlinkerNumber Number1("num-abc");

int counter = 0;

// 按下按键即会执行该函数
void button1_callback(const String & state) {
    BLINKER_LOG("get button state: ", state);
    digitalWrite(LED_BUILTIN, !digitalRead(LED_BUILTIN));
}

// 如果未绑定的组件被触发，则会执行其中内容
void dataRead(const String & data)
{
    BLINKER_LOG("Blinker readString: ", data);
    counter++;
    Number1.print(counter);
}

void miotPowerState2(const String & state)
{
    BLINKER_LOG("need set power state: ", state);

    if (state == BLINKER_CMD_ON) {
       digitalWrite(LED_BUILTIN, LOW);

        BlinkerMIOT.powerState("off");
        BlinkerMIOT.print();
        
    }
    else if (state == BLINKER_CMD_OFF) {
       

        digitalWrite(LED_BUILTIN, HIGH);

        BlinkerMIOT.powerState("on");
        BlinkerMIOT.print();
    }
}

void setup() {
    // 初始化串口
    Serial.begin(115200);

    #if defined(BLINKER_PRINT)
        BLINKER_DEBUG.stream(BLINKER_PRINT);
    #endif
    
    // 初始化有LED的IO
    pinMode(LED_BUILTIN, OUTPUT);
    digitalWrite(LED_BUILTIN, HIGH);
    // 初始化blinker
    Blinker.begin(auth, ssid, pswd);
    Blinker.attachData(dataRead);
    Button1.attach(button1_callback);
    BlinkerMIOT.attachPowerState(miotPowerState2);
}


void loop() {
    Blinker.run();
}